ANSI/NEMA EN 10250-2024

This standard covers enclosures for electrical equipment rated not more than 1000 V and intended to be installed and used as follows: a. enclosures for indoor locations, Types 1, 2, 5, 12, 12K, and 13; b. enclosures for indoor or outdoor locations, Types 3, 3X, 3R, 3RX, 3S, 3SX, 4, 4X, 6, and 6P; and c. enclosures for hazardous (classified) locations, Types 7 and 9 This standard covers the requirements to provide protection to the enclosed equipment against specific environmental conditions. The requirements of this standard mandate that enclosures and equipment shall be installed and used in accordance with the manufacturer’s instructions and 110.3(B) of ANSI/NFPA 70, National Electrical Code® (NEC®). This standard covers the requirements for enclosures that are installed and ready for use in nonhazardous (unclassified) locations. This standard also covers the requirements for dust-tight enclosures that are installed and ready for use where permitted by NEC® in Class II, Division 2; Class III, Division 1; Class III, Division 2; and Zone 22 hazardous (classified) locations as defined by the NEC®, or by ANSI/UL 121201, Nonincendive Electrical Equipment for Use in Class I and II, Division 2, and Class III, Divisions 1 and 2 Hazardous (Classified) Locations (UL 121201). Where dust-tight enclosures are integral to or incorporate separable electrical connections (e.g., plug and receptacle, plug and connector body, inlet and connector body) for use in Class II, Division 2; Class III, Division 1; Class III, Division 2; and Zone 22 hazardous (classified) locations, the combination shall be designed to ensure that current cannot be ruptured at the separable electrical connections while energized parts are exposed. This standard also references requirements for Class I; Division 1 explosion-proof enclosures marked Type 7 and Class II, Division 1 dust-ignition-proof enclosures marked Type 9. The reference requirements are in accordance with ANSI/UL 1203, ExplosionProof and Dust-IgnitionProof Electrical Equipment for Use in Hazardous (Classified) Locations (UL 1203), with the associated area classifications and installation requirements in accordance with NEC®. This standard supplements the requirements for enclosures that are contained in the individual product standards. This standard does not cover the requirements for the protection of the enclosed equipment against conditions such as condensation, gas vapor ignition, thermal damage, icing, corrosion, or contamination that may occur within the enclosure or that may enter via conduit or unsealed openings. This standard does not cover protection of personnel from contact with enclosed electrical equipment where the enclosures or equipment are incompletely installed or where enclosed electrical equipment has been rendered accessible for servicing, maintenance, testing, troubleshooting, internal measurements, calibration, or by damage. A product that contains features, characteristics, components, materials, or systems new or different from those in use when the standard was developed (and that involves a risk of fire, electric shock, or injury to persons) shall be evaluated using the appropriate additional component and end-product requirements as determined necessary to maintain the level of safety for the user of the product as originally anticipated by the intent of this standard.