ASTM D5364-14(2024)

  Section Introduction and Background   Scope and Objective 1 Referenced Documents 2  ASTM Standards 2.1  ACI Standard 2.2  NFPA Standard 2.3  ASME Standards 2.4 Terminology 3  ASTM Standard General Definitions 3.1  Applicable Definitions 3.2  Descriptions of Terms Specific to This Standard 3.3  Symbols 3.4 Significance and Use 4 Service and Operating Environments 5  Service Conditions 5.1  Environmental Severity 5.2  Chemical Environment 5.3  Erosion/Abrasion Environment 5.4  Operating Temperature Environment 5.5  Abnormal Environments 5.6  Other Operating and Service Environments 5.7  Static Electricity Build-Up 5.8  Flame Spread 5.9 Materials 6  Raw Materials 6.1  Laminate Composition 6.2  Laminate Properties 6.3 Design 7  Design 7.1  Assumptions 7.2  Dead Loads 7.3  Wind Loads 7.4  Earthquake Loads 7.5  Thermal Loads 7.6  Circumferential Pressure Loads 7.7  Load Factors 7.8  Resistance Factors 7.9  Loading Combinations 7.10  Allowable Longitudinal Stresses 7.11  Allowable Circumferential Stresses 7.12  Design Limits 7.13  Tolerances 7.14  Deflections 7.15  Critical Deign Considerations and Details 7.16 Fabrication 8  Fabrication 8.1  Reponsibility of Fabricator 8.2  Fabrication Facility 8.3  General Construction 8.4  Fabrication Equipment 8.5  Resin Systems 8.6  Reinforcement 8.7  Fabrication Procedures 8.8  Handling and Transportation 8.9  Erection Appurtenances 8.10  Tolerances 8.11 Erection of FRP Liners 9  Erection Scheme and Sequence 9.1  Handling and Storage on Site 9.2  Erection Appurtenances 9.3  Field Joints 9.4  Field Joints Lamination Procedure 9.5 Quality Assurance and Quality Control 10  Quality Assurance and Quality Control 10.1  Quality-Assurance Program 10.2  Quality-Assurance Surveillance 10.3  Inspections 10.4  Submittals 10.5 Operation Maintenance and Start-Up Procedures 11  Initial Start-Up 11.1  Operation and Maintenance 11.2 Annex    Typical Inspection Checklist Annex A1 Appendix    Commentary Appendix X1 References